Pecoware TBB-3000 Bedienungsanleitung

OWNERS MANUALOWNERS MANUAL MODEL TBB-3000PART# Q0373 MODEL TBB-3000PART# Q0373

OPERATIONWARNING!READ THE SAFETY AND OPERATION PROCEDURES BEFORE USING THE PECO BRUSH BLAZER. DO NOT LET ANYONE OPERATE THE PECO BRUSH BLAZER IF THEY

OPERATIONFORWARD MOVEMENTGrab the front handle bar with your fingers and the steering control handles with your thumbs. Push both steering control ha

OPERATIONGrab the left steering control handle with your left hand and pull back while at the same time grabbing the right steering control handle wit

OPERATIONTHE BRUSH BLAZER CAN EASILY THROW STONES, STICKS AND OTHER DEBRIS AT GREAT VELOCITY, POSSIBLY CAUSING PROPERTY DAMAGE OR PERSONAL INJURY.DO N

PUMP ADJUSTMENTTRAVEL ADJUSTMENT:1. With the machine securely supported on blocks, loosen the jam nut at the end of one or both FRS rods to be adjuste

PUMP BELT ADJUSTMENTThe pump belt should be checked periodically for the correct tension. There should be 1” of movement for 10 lbs. of tension applie

DRIVE BELT IDLER ADJUSTMENTWhen the blade engagement control is disengaged, the drive belt idler puts tension on the drive belt, allowing the drive be

DRIVE BELT ADJUSTMENTThe drive belt should be checked periodically for the correct tension. There should be 1” of movement for 16 lbs. of tension appl

DECK BELT ADJUSTMENTThe deck belt should move 1/2” with 18 lbs. of tension on the belt. To adjust the tension on the belt follow the steps below and u

DECK AND DRIVE BELT REMOVAL/REPLACEMENTUse the following procedure for removal and replacement of the drive and deck belts:REMOVAL:1. Remove the drive

2 PECO BRUSH BLAZERTABLE OF CONTENTSSAFETY ALERT SYMBOLSSafety Alert SymbolThis Safety Alert Symbol means: “ATTENTION! BECOMEALERT! YOUR SAFETY IS INV

DECK AND DRIVE BELT REMOVAL AND REPLACEMENTPUSH DECKBACK AS FARAS POSSIBLEFigure 5Figure 6REMOVEHARDWAREFigure 3REMOVE BELTFROM PULLEYFigure 7PIVOT TH

TRACK ADJUSTMENT/REMOVAL/REPLACEMNTREMOVAL: 1. Remove the tension from the front wheel by turning the tension bolt clockwise. The tension bolt is

CHARGING THE HYDRAULIC SYSTEMTOOLS REQUIRED:(1) AIR COMPRESSOR(1) AIR HOSE WITH 1/4” FEMALE COUPLER(1) CONTAINER FOR COLLECTING FLUID(1) HYDRAULIC CHA

CHARGING THE HYDRAULIC SYSTEM3. Attach the air regulator to the hydraulic oil tank cap with fitting and to the air hose. See Figure 3. Make sure t

WIRING DIAGRAMSEE PAGE 25 FOR WIRE LOCATIONAND WIRE CONNECTION TABLE24

WIRING DIAGRAMWIRE LOCATIONSWIRE CONNECTIONS25WIRE END PART# DESCRIPTION WIRE END PART# DESCRIPTION1AP00916 GAGE RING TERMINAL 5/16" 8B P0109 16-

BLADE SHAFT ASSEMBLYWARNING!STOP THE ENGINE, REMOVE BATTERY CABLE AND SUPPORT THE DECK BEFOREWORKING UNDERNEATH. FAILURE TODO SO MAY RESULT IN SERIOU

LABEL REPLACEMENT PART NUMBERSR1045R1044R2005R1099R2004R2002R2000R1091R1098R2003R1093R1040R2001R104727

BATTERY REPLACEMENT:1. Remove the deck and engine hood.2 Disconnect the negative (-) battery cable.3. Disconnect the positive (+) battery cable.4. Re

PLEASE NOTE: These are only recommended replacement times. The replacement times on the parts in this list will vary depending on the work environment

3 READ THIS OWNERS MANUAL CAREFULLY BEFORE OPERATING THE PECO BRUSH BLAZER. DO NOT ALLOW ANYONE WHO IS NOT FAMILIAR WITH THE SAFETY AND OPERATING IN

30HYDRAULIC SYSTEMEXPLODED VIEW ANDPARTS LIST

31TRACK ASSEMBLYEXPLODED VIEWAND PARTS LIST

DECK ASSEMBLYEXPLODED VIEWAND PARTS LIST32

TREE GATE ASSEMBLYEXPLODED VIEW ANDPARTS LISTCASTER ASSEMBLYEXPLODED VIEW AND PARTS LIST33

ENGINE HOOD EXPLODEDVIEW AND PARTS LISTBELT HOOD EXPLODEDVIEW AND PARTS LIST34

COUNTER SHAFT EXPLODEDVIEW AND PARTS LIST35Item# Part# Title Quantity1 TBB-0250 C. SHAFT ASSY. 12 N0149 C. SHAFT PILLOW BEARING 13 TBB-0247 C. SHAFT 1

FUEL LINE EXPLODED VIEW AND PARTS LIST36

TOWER EXPLODED VIEWAND PARTS LIST37

INSTRUMENT CLUSTEREXPLODED VIEW AND PARTS LIST38

DECK AND DRIVE BELTEXPLODED VIEW ANDPARTS LIST39

This label reminds you that flying debris is projected in the direction of these arrows. Anything or anyone within this field is in danger of being h

FRS ROD ASSEMBLYEXPLODED VIEW AND PARTS LIST40

CHASSIS COMPONENTSEXPLODED VIEW AND PARTS LIST41

HYDRAULIC COMPONENTSEXPLODED VIEW AND PARTS LIST42

BATTERY AND MUFFLER GUARDEXPLODED VIEW AND PARTS LIST43

44DECK TO CHASSISEXPLODED VIEW AND PARTS LISTSItem# Part# Title Quantity1 TBB2-0018 DECK MNTG. PLATE ASSY. 22 K1036 1/2"-13 x 3" ALL THREAD

NOTES

P.O. BOX 1197ARDEN, NORTH CAROLINA 28704(800) 438-5823 OR (828) 684-1234 FAX: (828) 684-0858EMAIL: [email protected]: www.lawnvac.com

5A. WHAT IS WARRANTED?PECO extends the following warranties to the original purchaser of each new PECO consumer product subject to the following limit

FEATURES AND CONTROLSTHE BRUSH BLAZER6ENGINE HOODBELTHOODFRONTCASTERINSTRUMENT CLUSTERAMPMETERHOURMETERLEFTSTEERINGCONTROLHANDLEKEY/STARTSWITCHRIGHT S

7FEATURES AND CONTROLSGAS TANKTREE GATEDECKSPINDLEHOUSINGCARBIDECUTTINGTOOTHBLADEBARHAMMERMODULETANK CAPCUTTING TOOTH

FEATURES AND CONTROLS8HYDRAULIC OIL TANKHYDRAULIC OIL TANK CAPKOHLERENGINEIDLERWHEELFRONTWHEELRUBBER TRACKDRIVE SPROCKETHYDRAULIC OIL FILTERBLADEENGAG

FEATURES AND CONTROLS9LEFT HYDRAULICPUMPBATTERYRIGHTHYDRAULICPUMPDECKBELTCOUNTERSHAFTFUELPUMPFUELRETURNFUELFILTER